Hall GTC Forum
https://hallgtc.com/forum/

Source for belt line molding / trim
https://hallgtc.com/forum/viewtopic.php?f=3&t=242		 Page 1 of 1
Author:  rockjumper [ February 8th, 2023, 3:32 pm ]
Post subject:  Source for belt line molding / trim
Howdy, folks. Anybody find a source for the belt line molding? I'm missing 10' of it. I'm also missing 27' of the rubber/vinyl insert on my existing molding. I've done tons of searching online, even checking Airstream and Revcon stuff, and this molding appears to be a custom made one-off. Of course!.

I see some suitable replacement molding, but that would entail a bunch of money and a lot of work drilling out and replacing all of the rivets. Trying to keep it original, if possible.

Jarod

Attachment:
IMG_6060.JPG
IMG_6060.JPG [ 1.49 MiB | Viewed 6354 times ]
Attachment:
IMG_6062.JPG
IMG_6062.JPG [ 1.45 MiB | Viewed 6354 times ]
Author:  Saraclaire [ February 8th, 2023, 4:24 pm ]
Post subject:  Re: Source for belt line molding / trim
I'm missing a big chunk of my rubber moulding off that trim too. Haven't found anything that i can slap on there yet personally. If i never find anything accurate I'll just get something that looks good enough from a distance.
Author:  rockjumper [ February 8th, 2023, 5:42 pm ]
Post subject:  Re: Source for belt line molding / trim
I'm confident I can find a good solution for the rubber. I'll let you know if I do. The best bet may be to search for "extruded rubber" profiles or catalog pages from extruded rubber manufacturers. Exact measurements will certainly help. The aluminum is another story..
Author:  NicksGarage [ February 9th, 2023, 5:41 pm ]
Post subject:  Re: Source for belt line molding / trim
Might be able to use a peel and stick side molding that is available in various sizes. The trim itself is probably going to have to come from another GTC, but I don't know of anyone parting one out.
Author:  rockjumper [ February 9th, 2023, 5:52 pm ]
Post subject:  Re: Source for belt line molding / trim
Yeah, that's what I expect as well. Thanks, Nick.
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/